Distillation is a process when water is boiled
the steam rises and when it is cooled, the water vapor converts back to
pure water. Distillation duplicates nature's process of purification of
water. In a controlled situation such as boiling water and cooling quickly
in a catchments storage tank or container, the process of cleansing occurs,
removing waterborne biological contaminants such as bacteria, viruses,
organic and inorganic minerals, chemicals, heavy metals, volatile gases
etc. Distillation purification removes more than 99.8% of all contaminants,
thus producing a very high quality of water. Independent Laboratory testing
proves that technologically advanced water distillers such as Divine are
effective at removing greater than 99.8% of all contaminants.
Divine Water Distillers are designed with advanced technology
incorporating many safety features with effective automatic system, yet
with the most simplicity to maintain and operate.
We are most impressed with Divine Water Distiller for many reasons
some of which are:-
A) very simple to install / operate,
B) very efficient and very reliable, minimal maintenance is only
needed,
C) only very minimal maintenance required
D) plenty of spare parts available with superb after sales service,
E) truly a very good value for money equipment that last for years
after years
In Brief
The Divine Water Distillers come equipped with everything that is needed
to connect to your water supply. A complete set of connectors are supplied
to cater for most tap fittings. The Divine units (except for the 16L model) also come with a pre-carbon
filter that removes VOC [Volatile Organic Chemicals] before the water
is channeled to the boiling chamber for distillation.
The filter is good for an average of 5,700 litres of water and depending
on the frequency of your usage of the Divine distiller it could last you
between one and one and a half year. Changing one pre-carbon filter is
very economical. Manufacturer of the Divine distillers recommends that
chemicals be removed by pre-carbon filter (first one supplied) before
boiling as boiling the chemicals in the water will created volatile gas
and it will vaporized. In an enclosed room such volatile gas will stay
in the room and breathing the gas is believed to be detrimental to our
health and hence the recommendation to remove them through pre-carbon
filter before distillation. Divine Distillers (except for the 16L model) also come with a post-carbon
filter as well, which is the final stage of the water purification
process. A sachet of coconut charcoal accompanies each distiller and will
last two usage or 5 to 6 months (each change is recommended for each two
and a half to three months). Coconut Charcoal in containers can be purchased
either at the time of purchase of a new Divine or can be purchased at
a later stage.
The Divine Water Distiller has a circuit board type of circuitry which
makes any maintenance or repair so much simpler than other automatic water
distillers. The Divine distillers boast of a simple and practical modern
design where it has NO mechanical floats and NO float seals. Other old
fashion design automatic water distillers that have these mechanical floats
and float seals often are the cause of distillers to leak, fail or create
problems. Detection of water level in the boiling chamber and holding
tank is done by sensors, thereby eliminating the possible failures of
floats, seals mechanical switches that are common in many automatic distillers.
Further there is plenty of room for easy access to the electrical connectors
thereby servicing the water distiller could not be simpler. The Divine
comes complete with the stainless steel boiling chamber on the top, and
the stainless steel storage tank below for the purified water, and is
virtually assembled. Installation is as easy as three steps. One; attach
the faucet on the front by hand as no tools are needed. This faucet with
sight-glass shows how much water is contained in the storage tank. Two;
unscrew one screw at the back of the unit to attach the pre-carbon
filter and slot in the post-carbon filter (except for the 16L model) that sits on top
of the storage tank. Three; attach an incoming water line to the distiller
with the sturdy white water tube and also tee-pipe connectors supplied.
Very easy to install compared to other automatic water distillers. Drain
valves are already installed on the Divine water distillers, and practically
no plumber is required. Just follow the simple installation instructions
which accompany the unit.
Both the heating element and the solenoid valve are stainless steel.
As in most distillers the Divine also has a pin opening vent in the cooling
coil for volatile gases to vent. The fan for the cooling coil is protected
with a shroud to prevent the fan blade from knocking the coil during freight
of the unit.
OUTSTANDING TWELVE YEARS LTD. WARRANTY
Divine carries one (1) full year warranty labor (2) full years warranty against defects in materials on all electrical components & other parts and twelve (12) years limited warranty on all stainless steel parts. If the unit is found to have defective stainless steel parts within twelve years from purchase the parts are warranted on a replacement of parts or cost.
This warranty is void if the damage of defect is caused by Act of God, accident, customer abuse, unauthorized alteration or repair, vandalism, misuse or commercial use. Any optional attachment is not included as part of this warranty. |
